Description

Caution:
1) As the zip library issue, you’d better download the 1.5.X version of IDE for upload the Marlin firmware
2)Do not plug or unplug and wire or module when power is on, do not even touch the board when power is on or your hand has static charge(you can rmove static charge by touching metal tap) .
3) Always double check power wire is properly installed. If you do not follow above move, you can damage the control board and your 3D printer
4) Pls Confirm that the A4988 driver install correctly on the Ramps1.4.

Product Specification:
(1) Mega 2560 R3 Board
(2) RAMPS1.4 is designed to fit the entire electronics needed for a RepRap in one small package for low cost. RAMPS interfaces an Arduino-compatible Mega with the Arduino-compatible MEGA platform, RAMPS1.4 has plenty room for expansion. The modular design includes plug in stepper drivers and extruder control electronics on an Arduino-compatible MEGA shield for easy service, part replacement, upgrade-ability and expansion.
(3) A4988 Stepper Motor Driver is built-in translator for easy operation
(4) LCD 12864 with Controller contains a SD-Card reader, an rotary encoder and a 128 Character x 64 Line LCD display.

Package List(without original box):
1x Mega 2560 board for Arduino
1x USB Cable
1x 3D Printer Controller RAMPS 1.4 Board（Red Color)
5x A4988 Stepper Motor Driver with Heatsink
1x 12864 LCD with control board
1x Smart Adapter
2x FC flat cable
3D printer board Marlin firmware installation guide: http://osoyoo.com/?p=1370, pls pay more about attention about the guide and download the correct marlin for the 12864 LCD. As the zip library issue, you’d better download the 1.5.X version of IDE for upload the Marlin firmware
3D Printer Controller RAMPS 1.4 interfaces an Arduino Mega2560 board. The modular design includes plug in stepper drivers and extruder control electronics on an Arduino-compatible MEGA shield for easy service, part replacement, upgrade-ability and expansion
With LCD 12864, you can easy connect it to your Ramps board using the “smart adapter” included. After connecting this panel to your Ramps you don’t need your pc any more, the Smart Controller supplies power for your SD card. Further more all actions like calibration, axes movements can be done by just using the rotary encoder on the Smart Controller. Print your 3D designs without PC, just with a g-code design stored on the SD card.
It is designed to fit the entire electronics needed for a RepRap in one small package for low cost
We are professional factory on making all electronics components based on Arduino and Raspberry Pi. And we also have processional engineer team to offer you tutorials which you can start from beginning. all documents (including code) For all kits from OSOYOO,Detailed tutorials including project introduction and source code CAN BE PROVIDED FOR FREE, Contact us to the email address: elaine@vership.com.